Woodpeckers MAGQUICK Dust Port Hose Fitting Deluxe Kit - MGQ-DEL-K

Woodpeckers MAGQUICK Dust Port Hose Fitting Deluxe Kit

2 x Dust Collector Side, 5 x Machine Side, 1 x Surface Mount

ref: MGQ-DEL-K

• Woodpeckers MagQuick Dust Ports use rare earth magnets to make swapping your dust collector hose a simple and painless task. By connecting the magnets to a steel ring (instead of magnets to magnets), you'll never have an issue with polarity alignment and you'll only have to buy one magnetic connector. We also designed an internal bevel at the point where the two fittings meet. The bevel guides the connection into proper alignment as the magnets pull the fittings together. On the outside of the fittings you'll find another bevel that slides into flexible hose without a struggle and a groove around the fitting so your hose clamp creates a perfect seal and will never slip. The 3 different robust fittings are injection-molded from high-strength ABS. The Collector-Side fitting has the magnets. The Inline Machine-Side fitting has a steel ring and connects hose to hose. The third fitting is a Surface-Mount adapter you can use to build customized collection ports.
• Take a look on the back side of the Collector Side magnetic port. You'll see another steel ring. The ring behind the magnets reinforces the magnetic attraction. When you place the Collector Side fitting onto a steel ring fitting, the magnet "sandwich" has 40 pounds of straight pull force. But, don't worry…just push the fittings apart at an angle, and they pop apart easily.
• MagQuick keeps your shop layout nimble and makes sure your dust collector does its job. Hard pipe dust collection makes it difficult to rearrange your shop if you buy a new machine or figure out a better arrangement. And every foot of pipe, elbow and machine drop reduces the effective air flow. But if you're moving your dust hose from machine to machine you want the kind of fast and secure connection MagQuick delivers. With a short section of flexible hose and a Machine-Side fitting on each machine in your shop, you can always have full CFM at each machine. If your machine doesn’t' have a factory-designed dust port, use the MagQuick Surface-Mount fitting to build one.